Unfortunately, the following products are missing: products
* LED Strips P65, IP67, and IP67HS sold in 5m rolls
* LED Neon sold in 5m rolls
* PLANET LED Panels available in bulk packaging of 6 pieces
Product sold only as a complete set
Product description
The MiBOXER receiver allows you to control the LED strip. The receiver is connected to the remote control using radio waves with a frequency of 2.4GHz. The receiver is mounted between the LED strip and the power supply, so it can be added at any stage of strip installation.
Connection diagram of the LED power supply, controller and LED strip
The MONO tape receiver is characterized by an innovative solution for mounting lighting elements. By connecting the MiBOXER receiver with the MiBOXER MONO remote control (available separately), you can easily control the tape connected to a given controller. The number of controllers that can be connected to a given remote control is practically unlimited.
Do not disturb function
"Do not disturb" function prevents the controller from turning on automatically after the power is restored in the event of a temporary power outage. The function can be activated and deactivated using the remote control.
Extended frequency range
The high and low frequency range has been extended to 16k-250Hz. In this way, the flickering effect is reduced, which allows for a smoother transition when dimming the light.
Greater lighting control possibilities
Possibility to connect up to 12 remote controls and save 4 scenarios
The receiver allows control using applications and voice assistants. To do this, you need to pair it with a Wi-Fi gateway (sold separately). Using the application, you can adjust the lighting to the rhythm of your day. Lower brightness of light at night or turning on the lighting in the room in the morning – many possibilities from one application.
The receivers have the function of auto-transmission of the signal sent from the remote control. This signal is transmitted from one receiver to another located at a distance of no more than 30 m. Compared to previous versions of the V2 controllers, the signal is transmitted faster and more uniformly. Appropriate arrangement of receivers allows you to control the lighting in the entire apartment using one remote control.
Possibility of signal transmission and synchronization
Pairing the remote control with the receiver is extremely simple. You should disconnect the main power supply from the receiver (1), then reconnect the power supply and, within the first 3 seconds, briefly hold down the previously selected channel on the remote control (2). The effect of correct pairing of the devices will be the LED strip (3) blinking three times.
Pairing diagram of the receiver with the remote control
